Double hole knuckle for D25...

OK, some questions....

1) Double hole knuckle from a d27 will fit the d25, right?

2) Is the outermost TRE hole further out than a single hole knuckle, or at the same place?

3) If the outermost TRE hole IS further out, and I use that to attach to the bell crank, does that improve steering ability by means of more leverage, or is the difference minimal?

4) Are both tapered holes smaller at the top? (ie. TRE nut at top.)

Thanks!

 

not sure but believe both 25/27 knuckles are interchangable

d27 double hole knuckle the inner hole is in the same place as the hole in a single hole. the outer hole is an inch and a half or so further out.

yes leverage is increased, minimal but noticable,but travel is less for the same amount of wheel travel

taper in the holes goes the same direction in both as the single goes. can't remember which way that is at the moment