PTO seal leak

Well my TC seals replacement seemed to work but the pto seal leak hasn't fixed itself yet. It's a Koenig model 50 that runs a front winch. Can I access the lower seal from the front or do I need to take the thing apart? I'd like to do a quick fix and get some driving time in. Also does anyone know a part number for it? The exploded-view drawing I have describes it as a 1 7/8" od x 1" id. thanks.

 

Yup, can be accessed from outside. Must take the drive yoke and shaft off and out of the way. The shaft should be 1" but there are some rare ones that are I think either 3/4" or 7/8", forget which. I'd measure to make sure. Most are 1" though. I "think" 1 7/8" od is right. I have the seal # at home but that won't do much as I won't be back on line until Monday . Any bearing or seal supplier can get this seal as it is a standard size used in other applications if you have the measurements. Nickmil.

 

Thanks nickmil, I was getting lonely. So now I get to lay under it again!

 

Have you rebuilt the PTO yet?. It's a simple #50 chain with sprockets and bearings- piece of cake. :hurrican: