1. Registration trouble? Please use the "Contact Us" link at the bottom right corner of the page and your issue will be resolved.
    Dismiss Notice

How did you make your Dana 20 tourque mount?

Discussion in 'Early CJ5 and CJ6 Tech' started by DanStew, Apr 5, 2005.

  1. DanStew

    DanStew Preowned Merkin salesman Staff Member

    I want to get a few pics on what you used for the Torque mount on the Dana 20 when swapping over from a Dana 18?? I have no mount for the 20 or know what even the stock one looks like when installed on the jeep.

    Thanks!
     
    DanStew, Apr 5, 2005
    #1
  2. DanStew

    DanStew Preowned Merkin salesman Staff Member

    Anyone!!! :)
     
    DanStew, Apr 6, 2005
    #2
  3. nickmil

    nickmil In mothballs.

    Dan,
    Most Dana 20's have a piece of casting that sticks out that's part of the front output housing. There should be two threaded holes in this. There is a bracket that is just a piece of right angle bent metal that bolts here. Would be real easy to build and then mount a bushing and bolt to. On the Race Jeep I actually did just that then used a neoprene bump stop to keep it from torquing over. Works well. Nickmil.
     
    nickmil, Apr 6, 2005
    #3
  4. DanStew

    DanStew Preowned Merkin salesman Staff Member

    OK. If that is all it is. I did see that piece of cast with the 2 holes in it. I could just reuse the rubber dana 18 monut and make a bracket to attach.

    thanks!!
     
    DanStew, Apr 6, 2005
    #4
  5. rocnrol

    rocnrol Member

    i dont use one :oops: :rofl:
     
    rocnrol, Apr 6, 2005
    #5
  6. Ghetto Fab.

    Ghetto Fab. Member

    Me neither.

    Kevo
     
    Ghetto Fab., Apr 6, 2005
    #6