1. Registration trouble? Please use the "Contact Us" link at the bottom right corner of the page and your issue will be resolved.
    Dismiss Notice

Dana 44 Lock Right installation.

Discussion in 'Early CJ5 and CJ6 Tech' started by 1957Willys, Jan 10, 2013.

Page 2 of 2
  1. Jan 22, 2013
    noahlon

    noahlon Old Fart

    Pine Ridge, AR
    Joined:
    Dec 22, 2010
    Messages:
    206
    I replaced the wheel bearings, and had to completly remove the backing plates. Removing the flanges was a real hassle tho. I don't think they were ever removed.

    A little heat on the flange while applying pressure did the trick.
     
    noahlon, Jan 22, 2013
    #21
  2. Jan 25, 2013
    1957Willys

    1957Willys Member

    Birmingham, Alabama
    Joined:
    Mar 23, 2012
    Messages:
    698
    How many times can the cross shaft retaining pin be reused? Mine isnt a roll pin is a tapered pin with a point?
     
    1957Willys, Jan 25, 2013
    #22
  3. Jan 25, 2013
    hotrod351

    hotrod351 Member

    Joined:
    Sep 30, 2006
    Messages:
    225
    mine didnt come with a cross shaft. but yeah = locktight on the bolts.
     
    hotrod351, Jan 25, 2013
    #23
  4. Jan 25, 2013
    nickmil

    nickmil In mothballs.

    Happy Valley, OR
    Joined:
    Sep 23, 2002
    Messages:
    12,529
    Can be re-used. Make sure you stake the hole it goes into so it cannot back out.
     
    nickmil, Jan 25, 2013
    #24
Page 2 of 2
New Posts