Hello, new Commando owner. I cannot find a heat riser for the right manifold for my Dauntless V6. Does anyone know where to find a...
Hi Folks! For those of you looking to swap a Dauntless V6 into your 4cyl Early CJ5, don’t hesitate to acquire that inexpensive Jeepster Commando...
Looking to rewire my 71 dauntless just curious to see how many circuits are really needed? Looking at painless dont think I need the 21 circuits...
Hello, I'm in need of a throttle/acceleration bracket for my 225. Is this a part also used on Buick 300, 340, and 350s? Anything similar out...
The PO of my ‘71 cj5 put custom pipes on, but they are straight from the manifold out the side with no muffler. Does anyone have any suggestions...
After some consideration and research, I am thinking about putting a manual tranny in my 66' commando. Leaning towards a 5 speed with overdrive....
My ‘71 with factory Dauntless is giving me grief. I can’t get it to stay running. I have a new fuel pump, new plugs, new wires new coil, new...
I have a '71 CJ5 with the 225 dauntless and a T-14 The PO put in a clutch, I dunno if it's the right clutch or if they were just outright...
This my first post here, and I have been using these forums as a guest before trying to get all the info I could, but I still have some questions....
So in my 1966 cj5 my t866 has been having some issues. Ive narrowed it down to the synchros being the issue, and I want to get all the info I can...
I have a 65 cj5 that I'm working on. The drivers side exhaust manifold is an off center dump (slightly towards the back) which was broke in two...
So i have the jeep running awesome. fires up easily, idles perfectly, loads of power, etc. its an hei at about 6-7 deg adv. no air leaks that i...
I Have the stock tuxedo park 4.88 locked axles, the dauntless 225 engine, and a failing t86aa tranny. With this set up I'm able to go about 55...
Separate names with a comma.
