I just installed my clutch pedal and did a “dry test” to look at the travel of the pedal. It is a new clutch, but the AA chain system and pretty...
Can someone please clarify how I am supposed to set the torque on the nuts on my front propeller shaft when I can barely get a wrench on the nut...
I read a post from 2007 on headlight buckets but wanted to get input before I blast off paint and damage the original finish (like I did with my...
I am pretty sure I am overthinking things, but when you drill a hole (other than for a ground) through a painted part (where my fuel filler is...
[ATTACH] [ATTACH] Calling @stericlan! I used a tintable urethane bedliner made by Dominion on the undercarriage surface of the tub and there are...
I rebuilt front standoffs and used Permatex contact cement to hold 1/4” thick neoprene rubber pads in place. There are two standoffs in back on...
I found a crack at one of the holes for the Tc drain pain. It looks like it would just affect the bite of the bolt going into that hole, not the...
I am resealing my tranny and TC with gasket sets from Novak. They recommend a thin layer of RTV on each side of the gasket. I have read to tighten...
Any chance that the 1 1/4“ nut that holds a D18 main drive gear onto a SM-420 main shaft is left handed? I’m having a heck of a time getting it...
This partially sandblasted sticker was on my fan shroud. I have not seen a similar sticker on this web site. If this from an aftermarket shroud or...
I have seen bare aluminum and body color VIN plates on this site. Which way did the plate come? [ATTACH]
Happy Sunday, everybody. From what I have read on this forum and what I have seen in the parts manual, my windshield hinges should be black...
Keep had a GM steering column that I replaced with a new flaming river column. This was the floor seal for the steering column. Assuming it fits...
I, like many people, have dozens of things I am bad at, but today I had the opportunity to find out what I am the worst at: adhesive caulk. I can...
I am trying to solve my rear diff (D44) leak. I assumed it was because I had scuffed the differential housing removing the old RTV, so I bought a...
I have two points of attachment for what I assume is for a piece of tire between the cowl and the front frame that are damaged. I don’t see these...
I put an MTS 1978-86 CJ tear gas tank in my 67 and am having a hard time finding a locking gas cal to work with the filler neck. The bottom of the...
Maybe a dumb question, but I am using this fitting to step down my fuel pump’s 3/8 inlet to the 5/16 fuel line coming from my tank. Do I need hose...
I installed a 15 gallon tank from MTS in the back of my CJ5 and started working on the fuel lines, but I’m having a hard time getting the filter...
I’m working on patching bad segments I cut out of my jeep and hope you guys can help. I have basic home tools - no metal brake, no cnc. But I do...
Separate names with a comma.