does anyone know if the holbrook long leaf spring kit uses a spring that i might find in a salvage yard. $850.00 plus shipping is out of reach for...
the intake manifold carb mount needs to be close to level so the float in the carb works properly.if you mount it to low you run into front...
did he use the gaskets ?many new style plugs use a tapered seat,if he is young he might not know of the gaskets
if you leave the collar out your 420 will probly pop out of high gear
i used a tilt from a 82 camaro ,no shift on it tilts $40 at the junk yard.used borgenson shaft with slip joint,double d on one end and splines to...
i used stock manifolds and single exhaust joining behind the trans fer case,all up hi inside frame
anyone know were to get new coil springs for the bottom of the seat on a 3b
i plumbed my air with pvc pipe, my shop is 48 by 26 an i have a air hook up every 10 feet around the inside wall. never hade any prpblem with it,a...
put a small hose on the bleeder and put the other end in a contaner with enough brake fluid in it to cover the end of the hose about 2",open the...
thanks, oldtime has some and i will get them.
Re: windsheild parts i need the channels that were welded to the windsheild frame on both sides for the soft door to slip into i have the lowers...
my 53 3b doesnt have the parts that a soft door slides into is there a place to buy these parts.thanks XX
i use a dog collar XX
i looked at electronic speedos but all i found were 140mph or 160mph a bit much for me if i could get an 80mph i would do that XX
vin thanks that is the solution to my problem.
33x950 on mine
yup it goes fast enough ,4.3 vortec engine 60 plus is ez,a little noisy with 33 swampers,and a lot spooky but i would like the odo to be correct...
i have a 3b with 5.38 diffs and would like to get the speedo a little closer was the output gear different with4.27 diffs i have 33 in swamper so...
i used the original pedels and hung them from a bracket with the original pivot from the frame.this was on my 3b.i cut the shafts with the pedels...
probly was overheated i dont think it would freeze crack that high. head is no good if the crack goes into the plug threads,i think you should...
Separate names with a comma.