Good afternoon to you all! It,s been a long while since I've posted anything on the forum, but my forgotten password is sorted out now. I'm...
I,ve got a noisy lifter after my rebuild. The engine was completely overhauled except for the cam and hydraulic lifters, and it's running like a...
I need some measurements for my rollbar. I just need the total height from the floor level to the top of the rollbar. Appreciated thanks,...
Hi all. I'm a bit worried about my engine temperature. I think it's running too cold.If I remember correctly, the correct thermostat is...
After my rebuild, I've got a noisy transfer case I think. I've done a "mini" rebuild on my Dana20 and T14.Bearings, oil seals and syncro only....
Hi all. I think the left front wheel of my Dana30's camber is way off. The bottom of the tyre looks to be running inwards towards the engine,...
This is for a 232 AMC without any smog equipment fitted. I don't have the original aircleaner housing, so there is no filter on the pipe running...
After a lot of searching, I've managed to find a good CJ7 hood. As far as I know this will fit a 75 Cj6? Am I right in saying this?
I've got a question about the body mount just infront of the rear shock absorber mount. The frame rails are running in an upwards direction to...
I've noticed this morning that the right side of the rear support on my 75 CJ6 frame is shorter than the left side. I don't know how I missed...
Hi all. I need some help again finding parts. I've got a set of vacuum wiper motors that is in good working order, but I only have one damaged...
I,m a bit pussled. All the wiring diagrams show the wiring of the brake light, but there is none on my speedo cluster. My original cluster only...
I've seen something on my 75 CJ6 that I haven't seen on any other pics I've found on this forum. There is a little raised foot support at the...
I'm about to order a rear valence panel for my 75 CJ6, but I can only find ones listed for early CJ5's. Do you guys know if they are the same?...
Hi all. I've got a question about the manual choke conversion on a Carter 1BBL. There is vacuum being pulled through the choke assembly, so do I...
Good morning guys. I'm in the process of rebuilding my 75 232 I6 CJ6. I'm in need of a new hood, as mine is beyond saving. Is there any...
Hi all. I'm busy with the restoration off my "split type" windscreen. As this is a box type frame, I would like to clean and protect the inside...
I need some help again guys. I ordered a new ring-gear for my 232, but it fits a bit too easily to my liking.It is not loose, but I can push it in...
What should the oil pressure be on a 232 I6 at idling and lets say 2000R.P.M. more or less? I want to buy a gauge, but I don't know what range...
I just received my new gearbox and engine mounts, and I've got a couple of questions. On the Dana 20 everything looks fine except for the...
Separate names with a comma.