That thought had crossed my mind but I didn't want the winch/plate kicking around it the back of the jeep and the fact that it is easy pickens for...
Hi all, I stopped by Harbor Freight Saturday and they had a great sale on the 12,000 LB winch, it was $300. I brought it home and there is not...
My engine runs really well, I don't notice the odd-fire lope. I did look at that doc and I didn't see my numbers on it.
OK, I'm feeling dumb, "I tried to think and nothing happened". I went back and reread the "Understanding the Odd-fire V6" and I was wrong in...
My CJ5 Jeep project is almost done, I was setting the timing on the V6 225 engine and after all the reading I've doing about odd-fire vs evan-fire...
Hi All, I put GL5 in my tranny and TC, now what do I do? I haven't driven it more than 2 miles sense I filled them up. Should I just drain it and...
Thanks for the physics lesson my friend, point well taken!!(y)
Hi Tarry, I'm a bit confused with the statement "increasing the angle at the front U-joint", I would think lowering the tranny and TC would...
Yes that is very true! It's strange how it was all working when I took it apart but when I put it all back together things just don't line up the...
Problem solved!! Thanks to all you who advised me to not messing with the tranny mount but advised to adding a bushing between the frame and the...
So I checked the level on the bottom of the frame right in the middle flat section, it was level, I then checked the level the best I could where...
I'm just wondering if I can drop the tranny and TC down about an inch, thus giving me more clearance on the 4 spots I highlighted above. What if I...
Good suggestions I may need to rase the body a bit.
The engine mounts looked pretty good when I mounted the engine!!
Thanks, I would have for sure forgotten to to that!! If I lower the tranny and T/C can that mount bolt flush to the cross bar or dies it need a...
Thanks for all the suggestions, that's the beauty of involving great minds. I have pictures. This first pictures is the block between the...
My transmission is a T-86. So I assume I need to start with a known frame angle and tilt down 5 deg past that on the motor/transmission?
So I took my CJ5 project for a spin up the driveway for the first time last night, it was sweet :watch:. I just finished mounting the gas tank and...
I was born in SLC, lived most my life in Provo, Worked at Hill AFB for 8 years and lived in Layton, now I'm back in Utah county living in Payson,...
Congratulations :D I'm not far behind you, I connected my 66 CJ5 to fuel this week, started her up and she ran great but had a leak in the fuel...
Separate names with a comma.