Thank You for the input. It's allways a pain to redue something, especially brakes, but at least now I know what should work. Thanks again.
Hi guys. I searched the forum and couldn't find exactly the answer. Long story short. Just finished frame up restoration on my 75 cj-5. Has discs...
Thanks for the input guys. I scored some manifolds so I will eventually be going with them and a single exhaust for simplicity and cost. I've got...
Hi guys. I'm tired of my fenderwell headers with pipes ending in front of the rear tires. No longer want the noise and am looking to go with...
Thanks for the input guys. I've decided to just use the fusible link for now. It's been a year long project so far and I want to get this thing...
Hi guys another question regarding the rewireing of my 75 CJ5. The EZ wire kit I'm using calls for the fusable link to be spliced into the main...
Thanks for all the input guys. Nothing beats expierience. I'm going with the crimp and heat shrink route. It's comming along nicely. Has to be...
Hi guys, I'm finally to the point in my rebuild to start rewireing. I'm using the EZ wire harness. What do most guys do when it comes time to...
Just curious if I got an oddball set of heads with my longblock or are all AMC 360 's this way? I put in an AMC 360 into my cj5 ten years ago....
Thank you for the answer and the pic. I was not relishing having to drill and tap the the pumpkin. I would have been really ****ed if I did it and...
Hi guys. I am in the middle of a frame up build on my 75 cj5. After years of rear pinion seal leaks I finally found out that the rear D 44 has no...
Great advice. Thanks for all the help guys.
Hi guys. My frame up restore of my 75 cj5 is to the point that I need to paint the tub. It is a 73 that has been sanblasted. Floors and hat...
It takes the place of the plastic bushing. I had no idea the steel bushing on the end was actually part of the "bushing assembly" until I looked...
Thanks guys. Looks like I'll be using acetone since I forgot to order their cleaner. Did the rust encapsulator stick well even without the rust...
Hi guys. My Eastwood chasis kit is almost here and I need to know a good cleaner to use to wipe the frame down with before painting. Something...
Hi guys. Saw an older post about guys having trouble finding a replacement for the plastic lower bushing in the steering column. Mine also was...
Thanks for the advice. A machinest might be the way to go, although the do it yourself in me tells me to try the grinder first. Daryl hooked me up...
Thanks for the pic. The area I'm talking about is to the left and down from the one you have marked. It's the one coming out of the large bore,...
OK after looking at the input gear which is a 18-8-23 it looks like he had t6he d18 mod done that I have read about on line. Not the expensive...
Separate names with a comma.