I rebuilt the carburetor and got a new gasket, which rules out a vacuum leak between the carb and intake manifold. I started it up and it ran...
I think it could be the gasket, so I'm getting a new one and will try that tomorrow.
If I shine a light down into the carb I can see the valves are closed and when I give it had they open up
Its the Rochester 2g, and all of the linkages with the choke and where the accelerator hook up look good.
I have a '67 with the dauntless v6 engine, and recently when I start it up, it runs way too high, like it's getting too much gas. I don't know...
So I finally had time to pull the cover off and look inside. It looks clean, but when you move the lever into first gear, it'll move into a...
I have a '67 cj5 with a v6 and a three speed transmission that has trouble staying in first. If I put it in first and try to go, the transmission...
The jeep is about done. I drove it the other day around the neighborhood after bleeding and adjusting the brakes again. It drives good, but makes...
Okay, I guess I read it wrong somewhere else and I figured that underneath the cap might be different between yours and mine. Thanks for the help,...
One more question for you guys. The number one plug on the cap is supposed to be to the right of the battery and other wires. But depending on...
Right, I didn't mean to put the one on the end. I have it starting with 1, and then 6 all the way to 2 in order
Chuck, I think my distributor is set up like yours. I have the first wire in the correct position and then 6, 5, 4, 3, 2, 1 in a clockwise...
Thanks for the help. I looked at the links and how they don't fire in even intervals makes sense, and the cap confirms that since the terminals...
Sweet, thanks! Hopefully that was causing it to run weird. Different question but same topic. Its okay if my number one plug faces towards the...
As a side note, we installed them counter clockwise in the order 1 through 6. It did start up but didn't stay running. It could be because the...
I searched and couldn't find anything for this particular distributor. I installed a hei distributor from crt performance in my 67 with the 225...
The seats are also all back in. The smittybuilt ones fit fine on the driver side bracket, but were too narrow for the passenger side bracket,...
I've been working on the jeep quite a bit, just haven't been updating this. The distributor came and I installed it except for connecting power to...
Raptor. I would recommend it. After three days i still haven't put anything in but its hardened nicely, has a nice texture, and went on easily.
I got the bed liner sprayed in today. I was really impressed with how well it went on. The gun worked well once I figured out that you have to...
Separate names with a comma.