The mounts are stock and the engine is to the drivers side. The frame that this combo came off of does have a spacer on the frame rail to push the...
Panzer, Thanks for the pic, do you have the overall dimension of the shaft you had modified? Did you have to put new holes in the cross member...
Here are the images Showing interference with bell housing/block: [IMG] Showing clutch bell crank shaft with engine in a position for brake...
Got the engine sitting in the Jeep (231 - 77, T14 and D20) and the pedals mounted (double master). If the engine sits finding its own location,...
Thanks for the info .... that is exactly what I needed. Did not think about the shaft having 6 points. Was thinking in threes only (one hand...
Is the distributor housing (HEI) the same for a even and odd fire 231 engine? Wondering if I could just replace the pick-up and change the cap.
Finally got the engines out and cleaning and decided to once and for all figure out what type of engine was really in the Jeep. I need to verify...
Well finally got really going on the Jeep(s). Month of July :beer: 1) Rebuilt Carb 225 V6 - Jeep 1 2) Ran 231 V6 - Jeep 2 (Donating Jeep)...
Okay so fianlly started on the Jeeps ... Cleaned out the Red one .... Specs Red (Mid to Late '67 - Origonally Spruce Tip Green) V6 - 225 Odd...
Separate names with a comma.