When I replaced my MC on my stock '73, there is a snap ring that holds the brake pedal push rod in that you have to remove. It was kind of fun to...
@nickmil-my u-joint angle is 1-2 degrees and do you mean the angle read on my driveline shaft? I think I need to go buy a new angle finder first...
Alrighty, so I had some vibration issues (I thought from my driveline angle) that I "solved" a week or so ago. I have a 73 CJ with a ~3 in lift,...
Correct. Spring-side of a seal is always on oil side. In this case, you don't want oil to move from the transmission to the transfercase, so the...
Well that's the last time I take my buddy's word for anything mechanical lol. The linkage bracket was catching on a lip on the side of my...
Yes, just a rebuild of the t-case, not something new. The transfercase is rebuilt properly, for some reason I just couldn't get everything to...
Nope. I ended up just pulling it off again as I couldn't get it to mesh, and my gasket ripped through one of the studs and got chewed up. It's...
@Posimoto-Yep, I used two studs just for the bottom two holes as I have absolutely no room on top of the t-case to get a stud back out. This...
Ok, so I just finished my transfercase overall. An idler gear, bearing, and arm were shot, along with some of the linkage. I also replaced the...
Yes, 73's do have an outer sleeve. Yes, that is what Strider is talking about, the removal of that thin sleeve. I used a torch, got the hanger...
Does anyone have a part number or anything else that can help me to find one of these mounts? I took it to NAPA and an old guy there recognized...
UPDATE: Got it pulled FINALLY. Ended up lowering the t-case/transmission/motor another couple of inches to be able to get a pivot extension and...
I can't remove the floors/access panel due to like 1/2 an inch of Herculiner/Line-X on the interior of the tub. Sorry, I should have been more...
And if the PO rhino lined the whole tub, what option does that leave me? It's almost like the bolt heads are recessed below the ear on the...
I CANNOT for the life of me get a socket on the two top bolts. Am I missing something? I lowered the transmission/transfercase a couple of...
I finally found the time to pull my t-case out. The PO fabbed up a crossmember that supports both the t-case and my T-18. I was going to use a...
Look identical to my '73 CJ5.
ncikmil- That's what I was afraid of. When I replaced the rear bearing, everything looked great and the fluid in it was clear. I guess I'll...
Went for a quick drive today and noticed some "new" vibration on acceleration that steadily got worse the closer I got to home. Crawled under and...
Can someone point me in the direction of an exploded parts diagram, specifically for the tailhousing on a 1973 Dana 20 transfer case? The ones...
Separate names with a comma.