Is there a source for new dana/spicer front spindles for the model 25/27 front axles? Cost? Thanks, Caterpillarman
hello, to my knowledge all 134 f head t-90 dana 18 jeeps had no spacers between the crossmember and frame, my 58 does not. when they put the t-98...
Cabover, thanks for the pulley link!
I have been following your posts, as I am doing a alternator conversion as well. I think you may have a 3 wire type alternator. That is the better...
Hello, I measured the frame width at the motor mounts and its a 1/4 to 3/8 wider than its supposed to be. Frame width is supposed to be 29 1/4,...
Hello, I am building a 58 cj5 with the F4 engine and a T-98. The 2 bolt holes in the right front motor mount do not line up with the 2 slotted...
Hello, I am putting a T-98 in my 58 cj-5. I got the trans bolted up to the engine, but I ran into an unexpected problem. I thought I could just...
Thanks, I got a seal from napa today. Caterpillarman
Hello, I am looking for the seal number for the seal that goes in the transmission to transfer case adapter. Thanks, Caterpillarman
Hello, I am putting a T-98 in my 58 cj-5. I need to know what the thickness is for the crossmember spacers that drop the crossmember from the...
Hello, I am putting a t-98 in my 58 cj-5. I am in desparate need of a 3rd gear for the tranny. Does anyone have any gears laying around, or a...
Dual Reservoir master cylinder? Hello, After a lot of looking around on this site, I am thinking of putting a dual master cylinder on my 58 cj5....
Hello, I am new to this site. lots of good info. I am working on a 58 cj-5, doing a ground-up restoration. I bought a prebent set of steel brake...
Separate names with a comma.