Thanks for the advice guys. I was, of course, hoping these parts would be worth a little more, but at the same time, I'm not surprised. I'll do...
Thanks for the reply Joe. I did consider keeping them for the "just in case" scenario, but the rebuild cost more than I would have liked and...
Hi everyone, I've recently finished rebuilding an odd fire V6 and have some unused parts left over and I'm considering trying to sell them....
I've seen two different set ups of distributor cap. I've seen one where the spark plug wire terminals are oddly spaced (like the cam lobes on the...
With the odd fire engine, you have to be careful when setting up the distributor. As I try to describe this, I'll use a points activated...
Okay, so my thinking wasn't that far off. Oil will migrate into the transfer case, and if left alone, will eventually even out the fluid levels...
Yeah Tim, I forgot about the oil through the bearing. So, what you're telling me, is that even though the fill plugs look to be at different...
Thanks for the reply Ron, I'm not really worried about anything, I'm just curious. I think I've answered part of my curiosity by looking at...
Hi everyone, This may be a dumb question, but I'm gonna' ask it anyway. I couldn't find an answer by searching. I'm just finishing up a...
Many times over the years I've had great success with this leak sealant when I wasn't in the mood for, or couldn't afford, more substantial...
I agree, side A toward the case. Here is a photo of mine coming off during my recent rebuild. I take lots of pictures because I know my memory...
Thanks Walt. Sorry for the delayed reply, but I'm on the road (as usual) and been out of internet access. I wasn't looking forward to the...
Hi everyone, I'm currently building a Dauntless odd fire V-6 engine. I started the project with two core engines, both of which had been...
I agree with the grease idea. If you use grease, make sure to use a grease with a low melting point so that it melts out and is replaced by gear...
I don't know what your tube fittings look like, but I've seen tube fittings at the rear corners that have been used as some sort of mount for a...
Thanks Doug, that makes sense. I'll go take some measurements and compare them to the specs listed in your link. I think this mystery may be solved.
Well, time for an update. I finally got around to removing the input shaft seal from my transmission adapter and discovered that it had two,...
Thanks for the input guys. I agree, the gasket should be pretty easy to make and if locating the actual gasket isn't possible, I'll take the time...
Hi everyone and Merry Christmas, I'm in the middle of doing an engine/transmission/transfer case rebuild. The engine is an odd fire V6, the...
Thanks for the reply guys. I tried to do a search for this, but as the techno-moron that I am, I never seem to be able to find much. I will call...
Separate names with a comma.