To bad your not local to me, I get them by the ziplock bag full from work, they are used in computer racks to hold rack mount servers in. Man I...
Sure can, but you have to use the mounts for the year spring and they also will have to be moved because the newer springs are longer.
I am going to make plates that are larger than the ones my cage will be welded to and bolt the two together. I think I would rather the body and...
Has anyone stuffed a V8 into one of the early CJ5's? Having a tough time finding a decent v6 around here, but rebuilt v8's are all over and...
Could try a pair of those extra long needle nose pliers and get in there to turn it. Worth a try anyway.
If you just have to get away from the steel I would go with a braided line, much more protection than a rubber line but just as flexible.
Yes for sure it will take an impact too get that off. You can also use a small propane torch to warm the nut a little bit, emphasis on the little bit.
I'll bet the windshield is just bondoed on the outside.
Use a hole saw and then just connect the dots from there with a jigsaw. It will take a little longer but my time is cheap. Of course if I had a...
I'm in the middle of rebuilding my 63 CJ5 and have the trans and transfer case out, I cannot get the front of the transfer case off it's like the...
Never seen them, I'm just making mine out of 16ga steel, just having the local steel place shear me up what I want then I'll drill the mounting...
Where does everyone find the caliper brackets? I have yet too find any either at a local junk yard or an OEM supplier, GM no longer makes or sells...
If your doing the power swap look for something from a 70's model full size or mid size car. All the truck boxes are mounted on the wrong side....
Separate names with a comma.