One of the good things with Dynamat is that you can polyurathane coating right over it. The paint does stick to it, I was going to use it on my...
Need some information on axle size. What is the difference between a narrow track and a wide track axle in width size? I have searched this web...
Hello Jeep and Jeepster aficionado’s! I have a 1967 Jeepster Commando w/ a Dana 27 w/ 3.73 gears, I am looking down the road (sort of speak) at...
Thank you to EVERYONE with all of your information. I finally had to take the jeep to a garage . . . they had found out that #6 plug was not...
In one of my earler posts I asked if where the EGR valve goes in to the bottom of the carb is needed and can I attach both breather and EGR valve...
I am a machinist, with a passion for mechanical problems. This jeep, all thou, is fun it is starting to ware me down, and **** me off! The help...
Where and how does one check for a vac leak? From earler post's vacuum should be around 20psi? With a timing light I an around 8deg bdc, from...
1. Ok . . . well I have put in a new re-manufactured 2 jet and intake gaskets . . . now the motor back fires up thru the carb going up a hill...
I have put on a new re-manufacture 2 jet, with new intake gaskets, and now it backfires both directions, going up a hill it will come up through...
The headers are from Hedman, wether they are tuned or not I am not to sure. Yes I have/had I hope have been sealed. I am going to start with 1...
Check out www.shoptask.com for one of the best 3-n-1 machines, I have seen. Coming from a machinist, it is quite impressive!
Does anyone have the link to DUI?
Un fortunatly the last vacuum gage that was put on the motor. The gage was all over the place. I guess that I will have to pick one up? What is...
Well I got the new intake mainfold gasket, and carb. Well . . . I think that I am 180 out. As far as the carb is conserned, how many turns should...
Ok Gentlemen, Thanks for the responce. I was getting 16+ mpg, with dual exhaust and stoch headers. The jeep runs OK? for the most part. I...
Separate names with a comma.