Do I have something strange? My bellcrank 'bolt' didn't have any needle bearings. It's smooth and sets into a bronze bushing. Is this a jerry...
Excellent. Now I can use less harsh language.
anyone have an exploded view of a dana 25 hub. I'm looking for the assembly order, which ring washer seal whatever goes where in what order....
When I made my engine a short block, I found one cast iron rocker arm shaft bracket and three aluminum. Is this normal? Or where they all...
I wanted to get some pictures here but the wear doesn't show up well. The pitting is deepish below the lip worn into the cylinder wall. The...
the top inch or so is beat to hell. It sat for long periods of time and was the victim of crappy shade tree rebuilding. As for what exactly is...
I'm looking at a high price rebuild anyway. The block although in good shape is tired. There's a laundry list of work. Sleeves wouldn't be much...
thoroughly tanked. Clean and pretty
Gasman, how do you use your jeep? Have you had any overheating problems 80 over?
How much should I worry about the F134 over powering the stock radiator? I didn't have a lot of time driving the jeep, but I did drive it a few...
Overheating because of having a bigger fire? The cooling surface area doesn't change. If the bigger fire is big enough to cause overheating,...
I should have a talk with my machinist about just how I intend to use my Willys. I don't want anything flexing or whatever nasty thing I don't...
I"m thinking about them. My machinist says the 080 over won't be a problem due to the very thick casting.
Exactly how far can I bore a F134. At some point a previous owner bored to 030, which is fine by me, but he also left the jeep sitting for a long...
I bought a new shaft for the D25 from Border Parts outside San Diego. The shaft arrived with no wear and a WO in the casting. It doesn't say...
Another trick to get bolts un-stuck is heat and beeswax. I use it all the time on steamships. Get it hot and jam the chunk of beeswax in it....
Mahindra in India made some like that.
Does anyone have expirience with the Selectro HD locking hubs? Anyone who would know if the hubs would engage the axles if the threaded portion...
I tried the resposible route and looked through the tech library and previous post to no avail. I have a Dana 25 front axle. This is my second,...
These came with the replacement Dana 25. They don't match the original boss. Are these normal for the closed knuckle on a Dana 25? The...
Separate names with a comma.