been attempting to remove the old sping eye bushings with absolutely no luck :( Tried using a huge c-clamp as a press.....no luck. Tried...
buddy of mine is looking for some military style tires......like what came on the older jeeps. Anybody got a source for these?
buddy of mine just picked up 2 sets of axles, both are '66 vintage (offset rear diff) along with i "think" a D18 t-case that's also offset for the...
just bought these: http://cgi.ebay.com/ebaymotors/ws/eBayISAPI.dll?ViewItem&item=7916665360&rd=1&sspagename=STRK%3AMEWN%3AIT&rd=1 Hopefully...
any input on what sort of carb top/"hat" would work good for building a snorkel setup? My 360 came with an aftermarket chrome "open" type of...
Picked up a really decent '74 DJ frame this morning (thanx m38a1diesel!) and am curious what needs to be done to swap over my CJ stuff to it?...
My buddy now has my softop and bows and we can't figure out where the bow bracket mounts on the tub rail :roll: Like an idiot, when i pulled...
Ok, i'm trading my bestop soft top to a buddy of mine even up for his hardtop & doors. His hardtop is off his '66 CJ5 and will be made to fit...
Welp, seeing how i'm now past the point of no return on this thing: 1. Leaf spring swaps: This had been mentioned before in one of my other...
will a '76 CJ I6 engine bolt up to a '73 304 V8 bellhousing? what size is a stock '76 I6?
after some real long/hard thinking, i'm leaning towards replacing the 360 that came in my jeep with a fuel injected 4.3 and the spare 465 tranny i...
anybody have some SOA pix they'd care to share? Specifically, the front axle and tie-rod area.......thinking i may go this route but not sure...
I didn't take auto-body in school......help a moron out would yas? ANYWHOS.....how in the world do you get the 90* bend made on sheetmetal?!...
alrighty, got the new front frame horns reinforced and the new bumper on (i know, i know.......gotta post some new pix) and after getting that...
question: When you guys weld in replacement panels, do you weld the entire panel in or just tack it in place then skim coat it with bondo?...
any chance someone has a '66 cj-5 wiring harness scanned into their PC? Can't find a book for it, and the one i picked up last night only goes...
not sure if i should post this here or in the intermediate section........but....... What paint are you guys using to paint your frames? A...
When you buy new floorboard sections, do they come with the body mount brackets? Reason i ask, is every place i've checked only shows the tops...
i've heard a few people say they swapped in other steering coloumns.....which one is the most popular? Survey says? I'm sure top-of-the-line...
anybody converted a D20 to twin stick?
Separate names with a comma.