Ok, so maybe I am whinning but does anybody have a hot tip for removing the leaf spring mounting brackets... short of a plasma, neumatic chisel...
Wow, the Sparkster is sharp. I just found those guys tiny ad in the back of a 4X mag not two weeks ago. Go Sparky!!!! :stout: Thanks for the tip...
Re: Spartan turn signal pics Yeah, me too. Will be refering back to that in time.
BINGO!!!! The reason I went to talk to him in person and see the shop. He is for real, been doing this for a very long time. Now again I caution...
Absolutely, custom shafts from this guy will run about $400 or $450 a set, but if I go Waggie length I can use those right???. Yeah, I know, I...
You could be right, but in my research I only found the AMC20 used with the Quadra-trak and that would be the off-set I am looking for. Please...
Maybe I am tell some of you something you already know, but after exhaustive research and turning over countless rocks in search of the elusive 70...
Thanks OrangeCJ5, that is a big help, at this point I am kinda leaning toward outboarding, (which I was originally trying to stay away from, but...
Thanks everyone for your input, any tips on material or techniques regarding this matter would be welcome. I am also considering using wrangler...
Ok, Kevo, this is the kind of info I am looking for, however I am still unclear as to whether you did or did not outboard the springs, I can't...
Stock width is about 50-51 inches. If I cut this down and have the axles made, where is the point that I really should outboard. Does anyone have...
I am still unclear on how wide I can go. 55", 58", 60". I was planing on 60 but that would put the mounting surface about 16.25" outside the...
The axle is out of a 78 dodge full size, I have rolled it up in front of the jeep and the axle tubes are long enough on both sides that I can cut...
Ok, this may be a dumb question but here it goes. I am modifying a Dana 44 front axle for my 66 Kaiser. Are people out boarding the springs in...
I have a Dana 44 in my 66 Kaiser... I think. The cover is about 9" wide about 9-9 1/2 tall, 2 1/2" axle tubes the the casting numbers threw me. I...
I think this will be my last axle spec question, I hope. Ok what is the deal with the GM 12 bolt. Why don't many manufactures make lockers for...
Yikes... :roll: my bad. yes I meant an 8.5 or better known as a ten bolt. Sorry for the bad info, I have been doing so much research lately I am...
Nope, I believe the company has been bought and sold once or twice as they have changed names. It’s now OX brand but they are still available. I...
Ok guys, my research goes on. Is any body aware of any serious issues in using a GM 1988 or later 9.25, 33 spline axle. My main concerns are...
Separate names with a comma.