motor had good oil preussure. I think I will see what size the crank is and see if it us still useable. I did a ring and bearing rebuild on it...
I know all the stamped numbers on all the rods are pointed to the same side. wich ever side the manual calls for. I thought maybe I put the piston...
I had a problem with my number one rod bearing in that it wore out with only about a few hours on the motor. I replaced it and it ran fine for...
my 55 cj5 won't shift into 4 lo. it will go into 4 high but then not let me shift the hight low stick into low range. it will let me shift into...
here it is . . . .
I am looking at the fitting right behind the distributer. it seems as that is connect right to the manifold
there is a little brass fitting by the distrubuter that has some vacum hoses going to it. one goes to the oil filler tube. where doses the other...
I have a set of rod bearings too that I am going to replace. the old ones looked great hardle any where but still goo to replace them. only some...
got my f-head apart today. it was smoking bad so I figured new rings and inspect all the berings. I got the head off and it seems to be looking...
they are for the rear. the old ones had a broken leaf and and a cracked laef
I was removing the old springs off my cj5 to put other stock type springs on the rear. they are from a 65 cj5. anyway they seemed to short so I...
there just round. didn't think there was screws there. maybe I will try to scrape some paitn and rust away to see if I can find somthing
More like a pan. concaved ont the end on the studs
I haven't noticed the screws but I will look. It also seems the studs are almost premently set into the drum itself. thats what is confusing me....
I am clueless now as to how to get my drum off so that I can but new wheel cylinders on the front. This is a 55 (at least taht what I was told)...
I figure thaty it would be difficult to put flat fenders form a cj2a onto a cj5. has anyone tried this?
changed the oil toonight and put some marvel mystery oil in it. it isn't smoking as bad now but I need to run it longer. no muffler on it so the...
I thought it was oil smoke but the more I think about it it may be form water getting into the cylinders. the raditor fluid seems a little oilly...
I got my 55 cj witht the 134 running today. problem is it is smoking. I was wondering what oil and how many quarts are supposed to be in this...
When I picked up my 55 cj5 I got a title to it of ourse. now that guy said it was a 55 cj5 and it clearly maybe as it is the f-head motor and thw...
Separate names with a comma.