You might want to pull two and measure. In my 74, the #1 exhaust pushrod was shorter than the rest.
Look for the nut on the front of the outside wheel well for the place where the bolt should go on the side. On the inner mounts, the driver side...
Not specifically about a carb, but you might want to emphasize the importance of correct timing and engine condition before attempting to make...
anything like this? http://www.emotoman.com/videos/dw.mpg
Ditto on the alignment. Fixed it for me in my XJ. First time it happened, scared me to death. I had just put on the new lift and was driving it...
Hope that's it.
Jayhawkclint - what liner did you use? that looks smoother than herculiner.
I rolled it in. I was able to do the whole thing (remove interior, prep, and line) in a day. It held up real well for at least a year, though I...
Here is what I did to my XJ. I used Herculiner. I really liked how it turned out, but the texture makes it a little difficult to clean....
If they said to measure a drop, then it was a voltage. With current flowing through the resistor, there will be a potential difference between...
Did you use the textured or smooth? On a related note, Durabak will gladly send you samples of the different textures and colors if you ask.
Could the engine vibrations cause something to short out? I had a similar problem when I wired my choke into the same circuit as the fuel pump....
Unless your temp sensor has a 1/2 npt fitting, you would need to use an adapter to use it in a cto opening. That might place the sensor portion...
It will be at the front next to the thermostat housing.
I had the same issue, so I installed a manual choke. Eventually I replaced the carb with a Weber. Supposedly, the choke linkage has a special...
http://www.superkleendirect.com/index.asp?PageAction=VIEWPROD&ProdID=100
Not if his 74 is stock. The blower motor will stick out toward the passenger seat. As far as I remember, the opening is pretty small. You'd have...
Do you live someplace where defrosters are important? If you'll search around this site and the internet, you should find several people who have...
As you probably already know, the defrosters are basically worthless. However, if you want to keep them, consider getting piece of rubber about...
The supertop is going to attach by rails, not snaps. There's not a lot that can be done to adjust it except maybe drilling some new holes in the...
Separate names with a comma.