I have a cv joint setup now on my AMC20. What rear axle do you have?
I have a 78 CJ5 with 304/T18/D20. I'm planning on a 4.5" lift. Rear axle choices are Wagoneer AMC 20, Ford 9 inch, or Dana 60. The AMC 20 would...
http://www.oramagazine.com/archive/2004/08-august/0204-feat-antiques.asp
Who makes a 64-65 CJ-5A wiring harness? One or two wires are different from CJ-5. I'm back on this project after a 10 year lie down.
Vid was impressive. Can someone tell me the metered or perceived power gain? What turbo, boost, carb was used? Any superchargers here to compare?
I checked out those threads but photos where missing and one actual turbo setup with a "runs great" description, couldn't view vid. Has anyone...
Has anyone Turbo or Supercharged an F Head? What would need to be done to the engine internals...64 model, never rebuilt.
Spring over, flipped and rotated axle?
With a T-18 and a 4" lift, you will need a new rear cv drive shaft and rotate the rear axle so pinion is pointing about 1.5 degrees below the...
I have stock 304 with Accel 4 barrel throttle body f.i., edel intake, dual exhaust, t-18, d20 with 2.46:1, 4.56 gears, 33" tires, and no...
I think a few differences might be: 1. front shock mounts 2. emergency brake brackets at rear axle 3. transfer case bolt hole locations 4. gas...
There are now aftermarket aluminum AMC engines: "Indy" I think. Loads of improvements, but you will spend some coin. An LS1 family Cheby engine...
The 10 inch wheel is typically about 3 3/4" backspace. I think technically backspacing should be measured from wheel mounting surface to bead...
With your setup (narrow track): 33s max with 10 inch wide wheels. These should stay under stock flares. I have had that setup. Go for some...
Rumor: Novak better quality.
The only way I have found to correct this is to increase the cross sectional area of the vent by: 1: increase the fitting/hose size. 2: add...
I'll make it easy for you, send me his address and then thank me for helping you out of a big mistake!
You might check to see if you have enough leg room with those seats. Some seats have alot of meat and padding at the rear mount areas that butt...
As I understand it, from the factory condition, the pinions on the rear axle and the xfer case rear output are close to the same (near parallel)....
I went the Woods route on mine also... rotating axle so pinion is pointing 1.5-2 degrees below rear output of xfercase, cv joint, long travel...
Separate names with a comma.