I have 35" BFG KM2's waiting to go on but want to get the axle issue straightened out before I use them on the trail. I'm looking into both...
Got a used straight Dana axle today from a friend. This should get me by for street driving but a flanged axle 44 or a full float conversion are...
I could put the original axles back in. I kept them for spares. I am also in the process of looking for a off set flanged 44. There is a Jeep...
Just replaced the rear axle shafts on my 67 CJ5 Dana 44 with new shafts from Kaiser-Willys auto supply. The old originals were straight but the...
Mostly Wisc. area. Loose dirt or sand hillclimbs, mud, boulders, sandstone and shale rock areas.
I run 33x12.50x15 TSL swampers with 44 rear and 27 front both with lock rites and 5.38 gears. Mild built 225 with t-14 trans and d18 case. I have...
I used a Willwood master cyl. and hanging pedal from Summit Racing and plumbed a adjustable limiting valve in the rear port and it works great.
I am looking for information on mating SM420 trans to Dauntless V6 with Dana 18 case. I know I have seen an article in the tech section before but...
I have the same Chevy caliper brackets as Dave T. Found them in the bone yard for $25 ea. Use the calipers from the same vehicle and use rotors...
Thanks for the tip. I got the info. I needed.
I have a 2 barrel Holley Projection unit that I would like to put on my 225 odd-fire. I have a DUI dist. on the eng. My question is: will the...
I would like to swap out the short front springs on my 67 cj5 with a pair of front springs from a 76 on up CJ.My question is, will the longer 4 in...
Thanks for the info. My other thought was to go with a full floater kit from Warn but that is expensive also. My problem is that I keep bending...
Can anyone tell me where to find 1 piece axle shafts for my 67 cj5 with a dana 44 rear. I have heard them mentioned in magazines but can't find...
Next time stick a screwdriver inbetween the teeth of two gears and you will be able to remove the nut without the shaft spinning. Or you could use...
Dave T was working on fitting a turbo to a F-head but it was more work than it was worth. That blower looks like a clean set up though.
Thanks for the info. I'll give these a try. :)
I'm having trouble finding motor mounts for my 67 CJ-5 w/225 V6. My local Carqwest and Napa stores can't get them. Anyone have a source to get them?
Dave, The pushrods I used are Federal Mogul/ Sealed Power part # RP-3173. I got them from Carquest. $ 1.90 ea. If you're going to replace one on a...
Warlock, The site you recomended was great, lots of info. After reading the explaination on how to install the HEI I think that I might have put...
Separate names with a comma.