I've been a member for a number of years - not so active lately. I recently rolled my R1 out of long-term storage, and had all kinds of problems....
Ok - mine is doing the same thing. New carb - flooded - I took in and had it rebuilt with a brass float. Now starts but floods out. When I...
I just want the record to show that I blasted every spot of green off my R1 and painted it with Concept Budweiser Racing Red, base coat, clear...
My R1 has the same setup Beeser is talking about....
If quacks like a duck - it's a duck. If the floors have surface rust, consider the floors goners. If you are ok with patches and bondo then - no...
Is this jeep yellow with diamond plating on tub?
Ok! Thanks.
Any ideas where a guy can get a new spline installed on a front drive shaft (v-6)? My local clutch place says they cannot get the new spline to...
Check with Beeser, he either has a complete system or is trying to get one.
Thanks for the info Fellas!
Checked the driveshaft - there is some wobble - not a lot but I assume it shouldn't wobble at all. I'll get it fixed to see if that solves it....
Was driving my latest project and noticed when in 4wd hi or low - there is a rumbling sound coming from up front when you let off the gas. I was...
Anyone have a source for the correct temp sending unit for V-6? The one I put in was from a parts house, I think it was for a Buick Skylark - not...
I'll check it out tonight. Thanks for the help! They really do push start easy in second gear. Dan
Thanks Brad! It's a rebuilt starter (swap thing). Guess I need to pull it and have a looksee. I will check the connections before - could...
Hope this isn't a topic like knuckle grease - but I've finally been able to drive the Jeep daily - but now sometimes when I go to start it there...
I used this kit several years ago on my 70'. Each bolt group was bagged and labeled. I thought it was awsome - cut my "bolt box scrounging" in half.
Separate names with a comma.