Has anyone had this Rochester 2 barrel 2G issue, have searched and not found anything. After replacing my 2 barrel cast intake manifold with an...
Came across this today. $100 for a jeep? World War II surplus frenzy hits Bay Area
Anyone get a moaning noise from their rear limited slip when first driving off? It sounds like that is where it is coming from, generally only...
Havent seen this swap before: http://tucson.craigslist.org/cto/4959878454.html Jon
Having decided I wanted a hardtop and debated aluminum and stainless I decided to go with fiberglass. Lacking a mold makes it difficult. I ended...
I finally fired up the rebuilt 225 today. What is this tapping noise? Here are some youtube links: http://youtu.be/8se_D-LULjw...
I have read through all the oil pressure/ pump threads I can find. I have a 225 v6, rebuilt by an engine shop. I am ready to start it but and cant...
I got a Dana 20 yoke for the rear of my Dana 18 for a double cardan yoke from Tom Woods Driveshaft. They said the splines would match up, which...
I got this idea from a guy who did it to his flanged D44 axle on the intermediate boards. I used 95 Geo tracker front disc and 2000 Nissan car...
I picked this windshield wiper motor linkage setup out of a suzuki XL-7 since out of every car I walked past in the junkyard the wipers assy...
Can someone take a photo of the proper placement of a CJ2A Frame VIN tag, around the 1946 era when the frame tag went on the outside of the front...
I am combining parts from 3 different Dana 44 19 spline axles. I just had a shop put in a powr-lok. When I put the axle shafts in and tighten down...
I got my Dana 44 tapered axle back from the shop which put my powr-lok in. When I go to put the axle shafts in they get to where the outer edge of...
I put my hood on this weekend and I have a 3/4-1" gap between my hood and fender on both sides. I cant figure out why, aside from the obvious of...
For tapered axle shaft (2 piece) dana 44 rears, do some have a one piece hub/drum combo? I just pulled apart an axle I got and the splines on the...
I am replacing the front diff and ring and pinion in my 77 Dana 30 front end. I bashed up the inner pinion bearing baffle (the baffle between the...
What is the flange sticking of the passenger side of my 76 Dana 30 front, just behind the yoke? [IMG] I would like to cut it off, its going on...
I have been search through exhaust post and havent seen this pop up. I have a 225 with AA headers in my flat fender project. The easiest way I can...
What do people do for the angle of the engine on engine installations? I installed my 225 v6 in my flatfender jeep basically flat, (no 1-3 degree...
I bolted up my in progress disk emergency brake today. Here are some photos. The disk and caliper are off the rear of a Yamaha FZR400. The caliper...
Separate names with a comma.