hello, I have an amc 20 rear axel on a 76 cj 7. Driver side is leaking oil badly, I have removed the axel but cannot seperate the flange from axel...
could someone post a link for the go for it draglink that flips the link arms, thanks kirk
I am working on a 76 cj7 with a 232, just bolted on power steering pump and realized that I needed a double pulley on water pump to drive the ps...
I do have a ground wire from batt. neg. to rear of speedometer housing and a ground wire from sending unit to frame on rear. The only thing I can...
74 cj5 304 can't keep gas guage working. I am on 2nd guage and sending unit from quadratech. The first was a lesson for me because I didn't have a...
Hello, my fuel and temp guage have pegged out to full and hot and stay there even when key is in off position. The guages and speedometer are only...
the speedo cable is new , the speedometer had a sticker on it " made in china" My rear diff cover , the oil plug will not tighten, it keeps on...
I bought a speedometer from Morris 4x4 and put 40 miles on it before it quit,sent it back, waited 2 weeks to get replacement, installed it today...
thanks for all the advise, I unhooked the speedometer cable behind speedometer and pulled cable out where i could see it. It spins all the time...
thank you for all the responses, Tim , I saw an earlier post by you with pictures of 2100 verses the 2150 and mine is a 2100, I think it has a...
one more question, I put a new speedometer from quadratech on and it works for about 10 minutes each morning then quits, what is the problem with...
I'm having trouble getting a rebuild kit for my motorcraft 2100 . both carquest and 2 napa stores say that the 2100 is a model number and to get...
I'm embarrased to ask this but here goes, the timing marks on my 304 have a R and an A on either end of the timing scale, which one is for before...
thanks for all the responses, I had lots of problems. I read the manual on carburators and learned that i needed to adjust the mixture screws all...
thanks for the suggestions, I checked timing this morning and it was still on 3 degrees btdc. It didn't backfire at all until it had run for about...
74 model with a 304 and it idles well but if I accelerate fast it will badkfire in carb repeatedly but will eventually speed up. I installed a new...
I took it apart again and put it back togeather with the shafts reversed from what the picture indicates on page 6-8 of the tom collins service...
Okay, I've just reassembled shift cover and reverse is right and forward, and 2nd is left and forward. I printed a copy of fsm from tom collins...
I was sitting in jeep with motor running, rear tires off, on blocks, I put it in what i thought was reverse and wheels spun forward: I have...
I am almost finished with a body off restoration of a 74 cj5 with 304 and t15 trans. While the body was off , I removed the top of trans to get...
Separate names with a comma.