I have a 73 cj5 with 360 v8, it has a straight shaft steering column now and I would like to change that to a tilt column. I changed the big bus...
I have a 73 cj5 with AMC 360 v8. I just installed a new starter, solenoid, and battery. With all new batt and starter cables. I go to crank it...
I put a new steering wheel on a year or so ago, but if I remember correctly. The adapter slides down on the splines on the shaft, the you put back...
I am getting back fires from the exhaust and sometimes through the carb. I tried today to tune it some more. I turned both of the screws and all...
I fixed the starting problem, loose wire to the starter. I am not trying to change to a 4 bbl card for performance but I have an old mc2100 carb...
I am trying to put a holley 4bbl carb on my stock amc 360 2bbl intake. I want to know if the following will fit....
Does anyone know where I can find a alternator warning light. I have searched all over the internet with no luck.
Ok so I guess i might have screwed up and got the wrong alternator. The one I have is a AcDelco 321-1044 100A. the oem p/n - 10463424. There is a...
where can I find The amps warning light socket for the cj5 or an aftermarket one. No one at carquest seems to know what i am talking about. Also...
Can you hook it up without the #1 terminal going to the ALT light. Could #1 terminal be hooked up to a volt gauge or not at all?
I got a gm alternator out of a truck the other day. It only had two wires hooked up. one to the battery terminal screw and the other to in a clip...
Does anyone know where to find a hazard switch mine is broke?
I have the same one, but mine is chrome on an AMC 360 with Motorcraft 2100 Carb. Mine sits flush with the bottom plate of the carb.
front [IMG] rear [IMG] I have new bushing for stock shackles, I assume they should fit.Have not really looked at it to much. Do you...
The shackles on this Jeep are homemade by PO. They seem to be sturdy but are way longer than stock. I posted this a while back on another thread,...
Thanks Tim for info. I think there is some play in the steering box. Is there a way to adjust that or do I have to replace parts in the box? I...
I have check for cracks in the frame. When I started rebuilding this jeep I boxed in the front of the frame and put supporting cross members in...
I know there are many threads about steering problems but I can't seem to find the answer I'm looking for. I have a 73 cj5 with 360 v8 no lift of...
thanks, I traced the wire back to the switch and found a break in the wire. I replaced the wire and she's running good now thanks again.
Thank you So much, it worked. So What does that mean. what do i need to do to fix it.
Separate names with a comma.