Thanks in advance, I appreciate the input. When making the noise during deceleration, and clutch is pushed in, the noise goes away and jeep...
I was finally able to get back to working my jeep. The jeep has a 134f, t-90, and d-18. The transmission was reassembled using NOS parts and put...
The cluster I bought was listed as t90 nos 63 and later cluster. I will go out and count the gears in old cluster to make sure that part is...
I just looked and my cluster doesn't have the tabs... my old one did.[IMG][/URL][/IMG]
Hey, I am back on the project. It has been a long drawn out harvest. My wife let me bring all the cleaned up parts into the house and I started...
Well I broke down and purchased all the parts I need hopefully. I was able to locate input shaft gear, gear cluster, reverse idler, reverse...
I don't know what the seal looks like, but if it has a spring on the inner lip of the seal, the spring side of the seal faces the bearing in the...
Thanks for the info. I have been pulling my hair out trying to decide what to do. After doing a little research on threads I am more than a...
I believe that is the seal that goes on the back side of the hub/rotor asm. It holds the grease in the wheel bearing cavity. Don't forget to put...
Thanks for all the support and it sounds like original still usable parts are out there. I just have trouble putting 50 year old parts back in...
Well I have no other options, the jeep must go on. I will be purchasing a new input shaft/gear 16 tooth, new 35 tooth gear cluster, and small...
I went out to shed and dug out other transmission and it also has a 33 tooth gear. That means the gears where wrong when I pulled them out. This...
I finally got the trans pulled apart. I have looked at buying the parts and according to add at walcks, the gear cluster to go with the 16 tooth...
[IMG]
What service manual did that photo come from Twin 2? Thanks for posting it.
[IMG][/URL][/IMG]
Hey look at me I can post pics... By the looks off the line in the middle of where the teeth used to be they were broke before, I think.
When you leave the engine in, how have you supported the rear of the engine since the motor mounts are in the front?
Congrats! Took me about two years before I drove mine, and it was worth the wait. Welcome to the addiction.
Separate names with a comma.