Cool. Copied and saved for future reference, hope you don't mind. On a side note, I would be careful about airing down below 10 psi on any...
Just to throw another alternative out there, I have been very pleased with the rear drive shaft I ordered from these guys....
That’s a very good point. My Mallory Hyfire came with a bypass plug so that if the box ever “conks out” it can be unplugged, the bypass plugged...
Would he still see a spark at the points with an MSD box? Since the current carrying load is handled by the box and the points are only a trigger...
If you're otherwise happy with how your Jeep rolls down the highway I'd stick with 33's. I run 33X12.5 Trxus M/T’s and they’ve been a great off...
It’ll look like a bubble at the bottom of the gas tank. Since you’ve got the under seat tank remove the sending unit in the top of it and you...
The MSD box eliminates the need for a ballast resistor. My ignition is a full Mallory system (HyFire CDI box, distributor and coil) which has a...
I would have to look when I get home to be sure but it looks like the 12S pump. Basically its what was available at O'Reilly at the time.
I know that a Mr. Gasket pump can be drawn through like you’re talking about because I’ve done it. Set it up with a momentary switch and use it...
http://kmjent.com/index.php/catalog/product/view/id/28172/s/high-flow-performance-electric-fuel-pump-140gph-universal-fit-3-8-npt-ports/ I’ve had...
That is correct and is what my front hubs had on them originally, but I too am cheap and had safety wire, pliers and the jig for drilling bolt...
I safety wired mine at all four corners. It takes a jig, lots of patience and 1/16” drill bits to drill holes in grade 8 bolt heads but it can be...
I see penetrating oil, easy outs and a lot of cussing in your future.
Right, actually looks a little shorter than the R-10 I used to have. Still not worth the effort, IMO.
I’ve been into a few cylinder heads now that both used and didn’t use lead additive and have found no difference. If you’re worried about ethanol...
Separate names with a comma.