Pretty sure I used a larger hole chev bell housing. Sounds like I may need to find an sr4 bell housing and just see how it fits with the jeep...
Thanks Nickmil. I have a good dana 20 for him with bronco gearing and factory twin sticks. Your comments bring a couple questions to mind....
Sorry. He has a 258 cid.
I have someone interested in purchasing a T-18 from me and installing it into a 1981 CJ-7 that currently has an SR-4 transmission. We need to know...
The T-18 that was in my 75 had a 1" spacer that enabled the fitting of the dana20 transfer case to it.
How far are you towing it?
On the high steer arms, we drilled the knuckles out for 5/8 studs, and just used wheel lug nuts on top since they have the taper. Probably...
Well, you need to determine if your regulator and generator are 6 or 12 volts. A 6 volt charging system isn't going to charge a 12 volt battery....
I did post it on the G503 board. I spend a lot more time on that board than here. But no one really knows this animal. It is a t-84c-1a. I am...
Just make sure the wipers do not hit them.
I am in the middle of rebuilding a T-84. It is an early 1942 ford gpw model with the fill/drain on the right side. I have found that it needs 2nd...
There is no such thing as a compound angle on a drive shaft. I know what you are trying to say, but an angle is just an angle, and it doesn't...
Separate names with a comma.