1. Registration trouble? Please use the "Contact Us" link at the bottom right corner of the page and your issue will be resolved.
    Dismiss Notice

Recent Content by olywrestle

  1. olywrestle
    Post

    225 W/Pro-jection

    So is this a direct swap onto a 2bl odd fire 231? http://www.holley.com/502-20S.asp
    Post by: olywrestle, May 2, 2006 in forum: Early CJ5 and CJ6 Tech
  2. olywrestle
    Post

    What do these fit?

    i own all 4.....
    Post by: olywrestle, Oct 13, 2005 in forum: Early CJ5 and CJ6 Tech
  3. olywrestle
    Thread

    What do these fit?

    Not sure what models of jeep these are off of, can someone help?
    Thread by: olywrestle, Oct 13, 2005, 8 replies, in forum: Early CJ5 and CJ6 Tech
  4. olywrestle
    Post

    Tranny Skidplate

    Says your hompage cannot be found.
    Post by: olywrestle, Jun 28, 2005 in forum: Builds and Fabricators Forum
  5. olywrestle
    Thread

    Tranny Skidplate

    okay so I swapped in my SM420 and have a D20. Anyone have any ideas or designs or pictures for a skid plate?
    Thread by: olywrestle, Jun 28, 2005, 8 replies, in forum: Builds and Fabricators Forum
  6. olywrestle
    Post

    Bracing the 'ol Saginaw

    Wehn Imounted mine, my box was so long i had to notch the cross member to get it too fit, my cross memeber looks different that the one in the...
    Post by: olywrestle, May 13, 2005 in forum: Builds and Fabricators Forum
  7. olywrestle
    Post

    York Compressor on 231/225

    not so worried about the plumbing and wiring as I am about the mounting. there is tons of info on plumbing, but not so much on mounting to a 231....
    Post by: olywrestle, May 9, 2005 in forum: Builds and Fabricators Forum
  8. olywrestle
    Thread

    York Compressor on 231/225

    Has anyone made this mount, to mount the York to a 225/231 for OBA. Or something similar to it?...
    Thread by: olywrestle, May 6, 2005, 4 replies, in forum: Builds and Fabricators Forum
  9. olywrestle
    Post

    Tube Bender Suggestions

    I will second the snap on one for quality ( it is what i have). But if you want to go cheap and are only using it for a few bends Harbor Freight...
    Post by: olywrestle, Apr 7, 2005 in forum: Builds and Fabricators Forum
  10. olywrestle
    Post

    CJ Cage Questions

    ahhh makes more sense thanks
    Post by: olywrestle, Apr 7, 2005 in forum: Builds and Fabricators Forum
  11. olywrestle
    Post

    CJ Cage Questions

    thanks you guys! i will have to see what I can figure out on my set up since I want to keep the rear seat
    Post by: olywrestle, Apr 7, 2005 in forum: Builds and Fabricators Forum
  12. olywrestle
    Post

    CJ Cage Questions

    I think I get what you are saying, do you have dual exhaust? If so how you going to tie in the front hoop? And also, How about the rear part...
    Post by: olywrestle, Apr 6, 2005 in forum: Builds and Fabricators Forum
New Posts