When I replaced my MC on my stock '73, there is a snap ring that holds the brake pedal push rod in that you have to remove. It was kind of fun to...
@nickmil-my u-joint angle is 1-2 degrees and do you mean the angle read on my driveline shaft? I think I need to go buy a new angle finder first...
Alrighty, so I had some vibration issues (I thought from my driveline angle) that I "solved" a week or so ago. I have a 73 CJ with a ~3 in lift,...
Correct. Spring-side of a seal is always on oil side. In this case, you don't want oil to move from the transmission to the transfercase, so the...
Well that's the last time I take my buddy's word for anything mechanical lol. The linkage bracket was catching on a lip on the side of my...
Yes, just a rebuild of the t-case, not something new. The transfercase is rebuilt properly, for some reason I just couldn't get everything to...
Nope. I ended up just pulling it off again as I couldn't get it to mesh, and my gasket ripped through one of the studs and got chewed up. It's...
@Posimoto-Yep, I used two studs just for the bottom two holes as I have absolutely no room on top of the t-case to get a stud back out. This...
Ok, so I just finished my transfercase overall. An idler gear, bearing, and arm were shot, along with some of the linkage. I also replaced the...
Yes, 73's do have an outer sleeve. Yes, that is what Strider is talking about, the removal of that thin sleeve. I used a torch, got the hanger...
Does anyone have a part number or anything else that can help me to find one of these mounts? I took it to NAPA and an old guy there recognized...
UPDATE: Got it pulled FINALLY. Ended up lowering the t-case/transmission/motor another couple of inches to be able to get a pivot extension and...
I can't remove the floors/access panel due to like 1/2 an inch of Herculiner/Line-X on the interior of the tub. Sorry, I should have been more...
Separate names with a comma.