I know the 7120 head is the best for the 4.0 liter conversion, but I'm seeing some 0630 heads advertised as HO heads . Are these as good as the...
Timgr...I guess I asked the wrong question....I do have the original iron 72 intake and carb, but what I was looking for was what newer intake...
I know this has been talked about before, but I just have a question or two. I have a 75 258 that I am going to put a 4.0 head on, a 7120. I know...
timgr.....orig enging/trans was a 232/3speed...which I still have....72 tub was shot so I picked up a 75 tub...then later the 258 combo...right...
Sounds like I might be better off keeping the 258, doing some mods to it....something to think about. Thanks for the feedback..:)
I have a 75 258 w/a t18 attached...also have a spare 304. My question is, will the bell housing and tranny fit the 304, or will I have to get a...
Thanks for all the replys...When I used to restore Mustangs, you were able to buy full factory assembly manuals...some were over 6 volumes...just...
Does any one know if Jeep Assembly Manuals are available? I have the FSM but looking for more info on assembly.
I'm changing from a 232/3 speed to a 258/T18. I know the 258 combo is longer than the 232 combo. Does any one know if I'll need to change the...
I ment to mention this in my reply....You mention you used a different cam and had low power..The 304 in question has a non adjustable valve...
Separate names with a comma.