If possible, I sand blast what I'm working on. If I am painting the part with a spray can, I use Epoxy enamel appliance paint. That stuff is...
I'm currently looking for one to go on Dad's '72.... Its like hens teef... [img]
Re: HD drive shaft on the cheap Na, not a dead horse... just that that smiley! BTW, that is my write up on how I built my own DC rear driveline...
:dead horse: http://www.jeepforum.com/forum/f8/diy-double-cardan-rear-drive-line-cj-1444192/
This is in my CJ7. I have a new blank to build a new dash. My plan is to use a Autometer programmable speedo in the center, and surround it with 4...
I hooked a test light up to the A terminal. It flashes as it is supposed to. I hooked it up to the S terminal, and it still flashes, but dimmer as...
Yup, its the fuel gauge. I tested it, and the ohms are correct. Correct voltage at the terminals. The only thing I question is the 5v shown on...
Worked on Dad's CJ5 today for awhile. I troubleshot the back of the gauge cluster. Everything checks out. Plus, there is a new temp sending unit,...
Re: Suspention Kits Questions, what to buy? Caster angle should be adjusted anyway, unless your still running bias ply tires.
2nd box got here today! [img]
Time to buy a new pump. Pull the dip stick and make sure fuel is not getting into the oil as well.
Got 2 boxes today, 1 more tomorrow :driving: [img]
I already have a spare for my 82, I may just adapt that to fit and wire it up with a push button in the hand pump hole.
Separate names with a comma.