1. Registration trouble? Please use the "Contact Us" link at the bottom right corner of the page and your issue will be resolved.
    Dismiss Notice

Recent Content by GwarJ5

  1. GwarJ5
    Post

    rocker arm not getting oil

    My pushrods were not replaced, I will mention this to the builder about the deck height and the possibility that they are too long. The lifters...
    Post by: GwarJ5, Apr 3, 2007 in forum: Early CJ5 and CJ6 Tech
  2. GwarJ5
    Post

    rocker arm not getting oil

    Well I took the motor out and sent it back to the rebuilder, on first inspection he noticed a couple slightly bent pushrods and the strange thing...
    Post by: GwarJ5, Mar 31, 2007 in forum: Early CJ5 and CJ6 Tech
  3. GwarJ5
    Thread

    rocker arm not getting oil

    My 225 is not getting oil to the drivers side rocker arm. I had the motor rebuilt and i just installed the motor. I searched the forum and tried...
    Thread by: GwarJ5, Mar 25, 2007, 10 replies, in forum: Early CJ5 and CJ6 Tech
  4. GwarJ5
    Post

    How does this tool work?

    I once tried to pull my old d44 hub off. I didn't have that puller but I did have a Snap On hydraulic puller. WOW, what a cool tool, that hub shot...
    Post by: GwarJ5, Oct 23, 2006 in forum: Early CJ5 and CJ6 Tech
  5. GwarJ5
    Post

    Dana 30 snubber

    Thanks for the info, my next step was bump stops. I'll add those Rancho stops to my long list of partsR) Thanks for the warm welcome:coffee:
    Post by: GwarJ5, Dec 15, 2005 in forum: Early CJ5 and CJ6 Tech
  6. GwarJ5
    Thread

    Dana 30 snubber

    I have to start off by saying this the best JEEP site there is!!! Anyway, I have done the D30 upgrade but my question is do I need to fabricate a...
    Thread by: GwarJ5, Dec 14, 2005, 4 replies, in forum: Early CJ5 and CJ6 Tech
New Posts