I will get pictures in a day or two. As far as details. I started with a fresh rebuilt 231 replaced the intake with a elderbrock proformer 4 bbl...
This is one of the best sites for FI info I have found. http://www.binderbulletin.org/forums/showthread.php?t=47254 I just got done fuel...
Quote: Originally Posted by zed I have a tach running from the tach output on my GM HEI odd fire dist. Since it's normalized for a tach i...
I should have been more specfic when I changed over from a ross box to manual saginaw. I used the lower steering shaft from a early 70's cj5. The...
Does anybody have a flaps part # for a 72-75 steering shaft u-joint?
The origainal was a bendix drum/drum I took the part # off of it and cross referenced it to the replacement model. The only diference between the...
I changed over to disk brakes a year or so ago on the front end. and have not had any problems till recently. The disks dont want to release. it...
I also went hydraulic on my 67 cj5. I used a ford clutch master cylinder and a pull slave and have had no problems with the setup.
Does any one know what the measurements for float level and drop are off the top of their head?
found and fixed my problem today and it is running great. Must have had a bad day when I installed the spark plugs the gap wasn't even close....
pulled the driverside valve cover off today and verified im not 180* out with the dist. plug wires correct. Drove it with the vac. adv....
Fast movement on the vacuum. I don't think i am 180 out but it don't hurt to check it again.
Separate names with a comma.
