1. Registration trouble? Please use the "Contact Us" link at the bottom right corner of the page and your issue will be resolved.
    Dismiss Notice

Recent Content by woodmandan2

  1. woodmandan2
    Post

    CJ5 Won't Start

    My Uncle was a CJ5 Mechanic in Vietnam. We went through everything together and he was stumped as well. Eventually we pulled out the jumper cable...
    Post by: woodmandan2, Apr 4, 2015 in forum: Early CJ5 and CJ6 Tech
  2. woodmandan2
    Post

    CJ5 Won't Start

    I know this is 3 years old, but I FINALLY found the issue. Turns out the body shop when the jeep was repainted was a bit harsh on the wiring...
    Post by: woodmandan2, Apr 4, 2015 in forum: Early CJ5 and CJ6 Tech
  3. woodmandan2
    Post

    CJ5 Won't Start

    I did not remove the distributor when working on the fuel pump. I also will ask how do I look to see if I am missing teeth from my timing gear?...
    Post by: woodmandan2, Oct 13, 2012 in forum: Early CJ5 and CJ6 Tech
  4. woodmandan2
    Post

    CJ5 Won't Start

    IT LIVES. Well, kinda. The lid was not sealing properly on the pump vacuum and it would not pump gas into the carb. I also found that the timing...
    Post by: woodmandan2, Oct 13, 2012 in forum: Early CJ5 and CJ6 Tech
  5. woodmandan2
    Post

    CJ5 Won't Start

    For whatever reason, the fuel pump/filter is not pumping gas anymore. I cracked open the fuel filter to find much sludge and junk inside of it for...
    Post by: woodmandan2, Oct 13, 2012 in forum: Early CJ5 and CJ6 Tech
  6. woodmandan2
    Post

    CJ5 Won't Start

    I must be litearlly the only person on this whole entire site who fails to use the search function properly. No matter what I type in, I cannot...
    Post by: woodmandan2, Oct 13, 2012 in forum: Early CJ5 and CJ6 Tech
  7. woodmandan2
    Post

    CJ5 Won't Start

    I also thought that the firing order might have been wrong when I changed the spark plug wires, however I rechecked it again and again it all...
    Post by: woodmandan2, Oct 13, 2012 in forum: Early CJ5 and CJ6 Tech
  8. woodmandan2
    Post

    CJ5 Won't Start

    F134 and Carter YF Carb. I believe I installed the ball check, and I felt like I tightened down the accel pump fairly good. I did check the...
    Post by: woodmandan2, Oct 13, 2012 in forum: Early CJ5 and CJ6 Tech
  9. woodmandan2
    Thread

    CJ5 Won't Start

    Hi All, I recently did a complete "tune up" on my jeep. It was failing to idle and was fouling spark plugs at a rapid rate. I replaced the...
    Thread by: woodmandan2, Oct 12, 2012, 23 replies, in forum: Early CJ5 and CJ6 Tech
  10. woodmandan2
    Post

    F-134 Carb questiions

    To the Original Poster, I replaced my Coil, Distributor Cap, Points, Condensor, and overall cleaned the entire distributor. It now idles like...
    Post by: woodmandan2, Oct 11, 2012 in forum: Early CJ5 and CJ6 Tech
  11. woodmandan2
    Post

    F-134 Carb questiions

    I am actually having the exact same problems you are describing. Two plugs are gas covered, two others are carbon deposited, and it will only run...
    Post by: woodmandan2, Oct 10, 2012 in forum: Early CJ5 and CJ6 Tech
  12. woodmandan2
    Post

    1961 President Red CJ5 Restoration Questions

    I just ordered a Factory Service Manual, a Master Carb rebuild kit, and some plug wires from Kaiser Willys. On top of that, I have a distributor...
    Post by: woodmandan2, Oct 9, 2012 in forum: Early CJ5 and CJ6 Tech
  13. woodmandan2
    Post

    1961 President Red CJ5 Restoration Questions

    Stout, I probably would have went this route if I read about this earlier. I have already purchased all of the parts to rebuild my distributor...
    Post by: woodmandan2, Oct 9, 2012 in forum: Early CJ5 and CJ6 Tech
  14. woodmandan2
    Post

    1961 President Red CJ5 Restoration Questions

    On top of that, is it possible that I could replace these in a single day? Does anybody have any instructions on how to set points and condensers?
    Post by: woodmandan2, Oct 7, 2012 in forum: Early CJ5 and CJ6 Tech