Patrick, Output drive gear? as in tcase output gear or input attached to the tranny? I have this same swap planned..
Ok, I will throw it in the parts cleaner and see if I can get a number up. I wiped it down but could not find a number.
Local NAPA and Partsmaster dealers cannot come up with a throwout bearing for a project. the one in it sounds like a bad rollerskate. The jeep is...
Not sure how the cutting brakes will work out with spools front and rear. Likely most folks wouldn't but I have seen it used in several apps and...
the 300 and the 20 twinsticked with the interlock pin removed will (allegedly) work to do a front dig. It is pretty important to me, as it was a...
In the middle of my own tranny t case issues, Buddy is putting his back to gether and aske me a question I don't know the answer to. He...
Well as usual, things are much clearer after mock up. The 205 will fit between the rails, even clocked although without a good mount it would...
Ya, one issue I forgot to metion was drive shaft length, I will loose almost 6 inches of length. I was concidering lenghtinging the wheelbase as...
I just acuired a np465 on a trade. It was working when removed, but they wanted an auto. It came with an adapter for an np205 on it. I was all set...
I have seen them blow more often than the lunch box lockers. But they were kinda a fad around here before the Aussies came out so cheap.
The paint burned off of mine the first time I ran it. Now they are just rusting.
Get a valve for a 68 ford f100 they are cable operated and availble at napa.
Separate names with a comma.