And the guy rebuilt the Mitsu case wrong. So now my backup needs a rebuild too. The hi-lo shift rail is turned 180 degrees such that the lever...
I'm taking it off to rebuild today. And probably putting the old mitsu tcase back on so there is no rush. Thanks nickmil. Also, I'll gladly take...
It's a square head. I'm going to try to source one locally tonight/tomorrow, otherwise, awesome I will contact you to order one. Should I use a...
What is the least time-consuming way to install the setscrew that holds the sliding-gear's shift-fork to the high-low shift-rod? Is a nearly...
Re: APB of sorts, 29t 10s OD: Read if made recent order from Herm or bought second-ha Thanks! p.s. Mods, thanks for moving this to the Early...
Re: APB of sorts, 29t 10s OD: Read if made recent order from Herm or bought second-ha Hmmm, I wonder if I should have posted this in the Early...
A package from Herm to me with 29 tooth 10 spline overdrive parts was not complete, missing the barrel gear (the planetary gearset). The...
Did you end up getting it? I love mine. If so, and you're interested, PM me and I can add you to an email list of other Mitsu Jeep owners.
Herm says that he's unwilling to do the 30 t OD bowl gear option. So I'm looking for cases, tons of Dana 20s around locally, but not any 1-1/4...
For a sanity check I installed the original gearset and the drag was as expected (exists but gears turn-able). I suspect that this means that I...
So I loosened both bearing cups and the output and intermediate gears spun again, easily by hand. However, I could see that the front bearing was...
Anything that I might have done to cause those gears to be too close together? Retainer bolt is not in yet, the shaft is still sticking 3/8" out...
I don't have assembly lube, but I used vaseline on the needle bearings. I'm going to check endplay more. Maybe see how the gears mesh with a...
Separate names with a comma.