1. Registration trouble? Please use the "Contact Us" link at the bottom right corner of the page and your issue will be resolved.
    Dismiss Notice

Ball joint

Discussion in 'Early CJ5 and CJ6 Tech' started by mikesgoat, Sep 8, 2013.

  1. Sep 8, 2013
    mikesgoat

    mikesgoat Member

    Fresno
    Joined:
    Jul 23, 2010
    Messages:
    92
    Dang it. I just ruined the threads on my ball joint that connects the drag link to the tie rod. The drag is a one piece. Can the the joint be removed and replaced or do I need a whole new drag link?!
     
    mikesgoat, Sep 8, 2013
    #1
  2. Sep 8, 2013
    tarry99

    tarry99 Member

    Northern California
    Joined:
    Oct 29, 2012
    Messages:
    3,784

    Pictures would be Great!....................I'm assuming your talking about the Tie Rod End? If it's not threaded on the end for replacement, that may already answer your question..........even if you could hold the ball tapered shaft from spinning, that is a hardened shaft and may not be able to be chased or re-threaded or cleaned up!
     
    tarry99, Sep 8, 2013
    #2
  3. Sep 8, 2013
    nickmil

    nickmil In mothballs.

    Happy Valley, OR
    Joined:
    Sep 23, 2002
    Messages:
    12,529
    Yeah, knowing what setup you have would be helpful. Do you have the stock Dana 25/27 with Saginaw steering? Have Ross steering with the conversion? Dana 30 front with Saginaw steering using a stock drag link? If the latter then there is one end that is replaceable and one end that is part of the drag link. Unless an oddball conversion the tie rod end "should" be replaceable. Be aware there are right and left hand threaded tie rod ends. Not the tapered stud part but the part that threads into the drag link or adjusting sleeve.


    Sent from my iPhone
     
    nickmil, Sep 8, 2013
    #3
New Posts