Would you run this axle stub or replace?

So here's the deal, I'm in the process of changing the front axle shaft u-joints and one of the ears on one of the axle stubs is damaged due to some genius (me) removing the old u-joint or a previous genius (P.O.) installing them wrong. Either way the old joint had been in there for at least 16 years, and much longer I assume. So here are a few pics, do you guys think this is usable or should I spring for a new axle stub.

 

Any way to blow the pics up? Kinda hard to tell for my eyes anyway.

 

my eyes aint that good mike .

 

Does this one use the bearing retainer clips on the inside or outside? Can't really see if there is a ring groove on the outside.

 

This one uses the retainer clips on the inside. I'll see what I can do about the pics, there is a fair amount of scoring on the inside surface.

Sent from my LS670

 

Going to guess if the snap ring surfaces are still good and the caps remain a bit of a press fit, it will go another 16 years.

 

Sent from my LS670

 

Kind of what I was thinking. It only gets put into 4 wheel drive a few times a year, and it is always slow speed stuff.

Sent from my LS670

 

Here are the same pics, just bigger. For some reason the post preview shows them large and the actual post show them small.

 

I would clean it up and check for inside roundness (mic) and if that is OK then I would go with it.

 

Thanks for the replies, I will clean it up and see how it goes together.

Sent from my LS670