1. Registration trouble? Please use the "Contact Us" link at the bottom right corner of the page and your issue will be resolved.
    Dismiss Notice

Need seat measurements for an M-38...

Discussion in 'Flat Fender Tech' started by Jordan, Apr 26, 2012.

  1. Apr 26, 2012
    Jordan

    Jordan Member

    Joined:
    Oct 3, 2011
    Messages:
    52
    Can any of you gentlemen give me a measurement from the top of the driver's side seat frame down to the bed (behind the seat) on an M-38 or CJ-3a jeep? I also need the measurement from the front bottom of seat pan to the floor.

    Thanks,

    Jordan
     
    Jordan, Apr 26, 2012
    #1
  2. Apr 28, 2012
    duffer

    duffer Rodent Power

    Bozeman, MT
    Joined:
    Sep 17, 2009
    Messages:
    4,519
    Well, I can get you this but its going to have to wait until it stops snowing. Figured someone on here would have one in the garage.
     
    duffer, Apr 28, 2012
    #2
  3. Apr 28, 2012
    Jordan

    Jordan Member

    Joined:
    Oct 3, 2011
    Messages:
    52
    Thanks John. If you can get to it when you can, that would be fine and much appreciated.

    Jordan
     
    Jordan, Apr 28, 2012
    #3
  4. Apr 29, 2012
    duffer

    duffer Rodent Power

    Bozeman, MT
    Joined:
    Sep 17, 2009
    Messages:
    4,519
    I lied---- Seats no where to be found for the 3A, 2A has a cobbled bench seat. The GPW/MB measurement is 20.25" if that does you any good. Might be the same.
     
    duffer, Apr 29, 2012
    #4
  5. Apr 30, 2012
    garage gnome

    garage gnome ECJ5 welder

    Western MA
    Joined:
    Jun 19, 2009
    Messages:
    3,092
    Do you still need them? I can measure my 3A seats.
     
    garage gnome, Apr 30, 2012
    #5
  6. May 4, 2012
    Jordan

    Jordan Member

    Joined:
    Oct 3, 2011
    Messages:
    52
    Yes. If you are able. I still need them.

    Thanks,

    Jordan
     
    Jordan, May 4, 2012
    #6
New Posts