1. Registration trouble? Please use the "Contact Us" link at the bottom right corner of the page and your issue will be resolved.
    Dismiss Notice

Rear Crossmember to Frame Reinforcement "V" Bracket

Discussion in 'Early CJ5 and CJ6 Tech' started by 1960willyscj5, Jun 26, 2010.

  1. Jun 26, 2010
    1960willyscj5

    1960willyscj5 Well-Known Member

    Mesa, Arizona
    Joined:
    Nov 27, 2006
    Messages:
    2,793
    This part is listed for 41-64 MB, GPW CJ-2A, 3A, 3B, M38 but not for the M38A1 or the CJ5.
    http://www.kaiserwillys.com/product/1346/willys_rearbumpers
    Does any one know if it can be used to replace the one used in the CJ5?
    Some wonderful PO done torched the one in my '60 out and I would kinda like to replace it. Or to even know if it is a necessary part.:?:hurrican:
     
    1960willyscj5, Jun 26, 2010
    #1
  2. Jun 26, 2010
    Warloch

    Warloch Did you say Flattie??? Staff Member

    Falcon, CO
    Joined:
    Mar 4, 2003
    Messages:
    5,470
    Not required - I pulled mine when I put a rear tank inside the frame there. If you going to hook up a trailer, just make sure it's attached right if you remove the V member.
     
    Warloch, Jun 26, 2010
    #2
  3. Jun 26, 2010
    1960willyscj5

    1960willyscj5 Well-Known Member

    Mesa, Arizona
    Joined:
    Nov 27, 2006
    Messages:
    2,793
    I have a 2" box tube welded to the bottom of the bumper/crossmember which I may reinforce with square ubolts before I go towing any where except my yard. My pickup won't fit in my back yard through the gate but the Willys will. Can even back the trailer around to where I need it.
     
    1960willyscj5, Jun 26, 2010
    #3
New Posts