1. Registration trouble? Please use the "Contact Us" link at the bottom right corner of the page and your issue will be resolved.
    Dismiss Notice

Clutch Order Of Installation

Discussion in 'Early CJ5 and CJ6 Tech' started by scarecrow, Oct 5, 2008.

  1. Oct 5, 2008
    scarecrow

    scarecrow Member

    South Jersey
    Joined:
    Oct 9, 2007
    Messages:
    127
    OK, Have new Sachs diaprham clutch kit that came with pilot shaft & throw out bearing. Motor & trans are out of the Jeep & will be installed togeather. Do I remove the pilot shaft afer the clutch is in or after I install throw out bearing, clutch fork & bell housing.:? Thanks :)
     
    scarecrow, Oct 5, 2008
    #1
  2. Oct 5, 2008
    Mcruff

    Mcruff Earlycj5 Machinist

    Albertville, AL
    Joined:
    Sep 22, 2002
    Messages:
    5,349
    Remove the shaft after the clutch is installed on the flywheel.
     
    Mcruff, Oct 5, 2008
    #2
  3. Oct 5, 2008
    Patrick

    Patrick Super Moderator Staff Member

    Los Alamos, NM
    Joined:
    Sep 22, 2002
    Messages:
    8,360
    If you mean the alignment tool, yes, remove it after the pressure plate is tight, and before you install the bellhousing..
     
    Patrick, Oct 5, 2008
    #3
New Posts