1. Registration trouble? Please use the "Contact Us" link at the bottom right corner of the page and your issue will be resolved.
    Dismiss Notice

Roll Bar- For Luke

Discussion in 'Jeepster Commando and Commando Tech' started by grouperboy, Jul 22, 2008.

  1. Jul 22, 2008
    grouperboy

    grouperboy n00b

    Tallahassee-North...
    Joined:
    Feb 4, 2008
    Messages:
    297
    Guy that I sold my 67 commando to wanted to know the dimensions of the custom roll bar that I have on my 70. It looks like 2' metal tubing, maybe 2.5. The base plates are 6" across, and have two bolts, bolted against another plate under the body. See here:

    [​IMG]

    Underneath:

    http://i244.photobucket.com/albums/gg29/grouperboy/DSC00222.jpg

    This bar is not tied into the frame, but it COULD BE, as the PO built new supports for the seat seen here:

    [​IMG]

    The rear support bar rises 7.5 inches off the rear wheel well, and connects to another tube for 19 inches to the main top most bar.

    [​IMG]

    [​IMG]

    The lower part of the main bar jogs over to clear the weld joint on the floor seen here:

    [​IMG]

    [​IMG]

    Top bar rises a total of 43.5 inches off the floor. The small "jog" is 7 inces out of the total 43.5 Width of the bar is 48 inches

    [​IMG]

    [​IMG]
     
    grouperboy, Jul 22, 2008
    #1
  2. Jul 22, 2008
    HeavyIron

    HeavyIron Member 2024 Sponsor

    So Cal or East...
    Joined:
    Oct 1, 2007
    Messages:
    574
    Oh good stuff there grouperboy :D:beer::D
     
    HeavyIron, Jul 22, 2008
    #2
New Posts