speedo gauge wiring ?

I've been working on rewiring the cj5(again) and I was wondering if anyone has a detailed wiring diagram of the speedo or know how it is wired up ? I took a pic of the speedo.. it is at:

http://bonehead.transamrit.net/cj5/cj5wire 002.jpg

 

Greatings from the Oregon Coast, try these links:

http://users.adelphia.net/~john.strenk/Gauge%20web%20page/basic_troubleshooting_for_cj_gau.htm

http://www.vernco.com/sparks/id697.htm

Hope this helps.

If needed I have my instructions for my painless that I could scan and send to you as well. Send me a PM if needed.

 

My speedo doesn't work, so I just took my speedo cable off that connects between the back of my speedo and the side of the transfer case. I then screwed a brass cap on were the speedo cable went into the t-case. I basically take off anything that doesn't work that I don't need since my jeep is an off-highway vehicle. Anyone see a problem with just putting the brass cap over where the speedo cable came out of the t-case?

 

I don't see a problem, mine the speedo cable was remove and there wasn't anything covering the fitting. Then again wondering if I bought someones parts Jeep.

 

bergy9: Thanks for the links.. Good info on those pages. It dose not tell me exactaly how the speedo needs to be wired up. I do not want to wire it up using the "trial and error" method.. I look at the front of the speedo, and then the backside, and I cant for sure tell which connector is for.