1. Registration trouble? Please use the "Contact Us" link at the bottom right corner of the page and your issue will be resolved.
    Dismiss Notice

T14 vs. T150

Discussion in 'Early CJ5 and CJ6 Tech' started by Toolmaker, Dec 5, 2007.

  1. Dec 5, 2007
    Toolmaker

    Toolmaker Member

    Westminster, SC
    Joined:
    Oct 3, 2005
    Messages:
    132
    Would it be worth my time to swap out my T14 for a T150? Is a T150 significantly stronger than a T14? The ratio's of the T150 seem to be better spaced than the T14. I already own the T150 and a friend of mine has a Jeep to GM bellhousing adapter I can get. What do ya'll think?
     
    Toolmaker, Dec 5, 2007
    #1
  2. Dec 5, 2007
    timgr

    timgr We stand on the shoulders of giants. 2022 Sponsor

    Medford Mass USA
    Joined:
    Aug 10, 2003
    Messages:
    23,596
    A T-150 will only mate with a Dana 20.

    Yes, stronger than a T-14.

    Someone here has used the T-15 with the V6. It's even stronger than either the T-150 or T-14, and can be used with the D18. Not sure of the details, other than it's been done before.
     
    timgr, Dec 5, 2007
    #2
  3. Dec 5, 2007
    Toolmaker

    Toolmaker Member

    Westminster, SC
    Joined:
    Oct 3, 2005
    Messages:
    132
    Why? Unless I'm mistaken it has the same 6 spline output as a T90, T15 etc..
     
    Toolmaker, Dec 5, 2007
    #3
  4. Dec 6, 2007
    timgr

    timgr We stand on the shoulders of giants. 2022 Sponsor

    Medford Mass USA
    Joined:
    Aug 10, 2003
    Messages:
    23,596
    It uses a rear output seal, and the bull gear has a shoulder for that seal. There's only that one D20 bull gear available for the T-150, and it has the wrong tooth helix for a D18.

    You might be able to remove the seal and use the D18 bull gear, but I don't know of anyone that has done it.
     
    timgr, Dec 6, 2007
    #4
New Posts