1. Registration trouble? Please use the "Contact Us" link at the bottom right corner of the page and your issue will be resolved.
    Dismiss Notice

Axle Bearings

Discussion in 'Early CJ5 and CJ6 Tech' started by ib4classics, Jul 3, 2007.

  1. Jul 3, 2007
    ib4classics

    ib4classics Member

    Johnson City,...
    Joined:
    Feb 13, 2007
    Messages:
    94
    Sorry for the previous wrong thread. 1961 CJ 5 stock. Dana 44 19 spline. Replacing the axle bearings. The drivers side sits about 1 to 1 1/2 inches in from the raised part of the axle. That would be toward the wheel.
    The passengers side sits up against the raised portion of the axle. Is the drivers side no on far enough?
    Also I have a cracked hub on the drivers side at the end of the key way.
    Thanks
    John:rofl:
     
    ib4classics, Jul 3, 2007
    #1
  2. Jul 3, 2007
    jpflat2a

    jpflat2a what's that noise?

    Hermosa, SD
    Joined:
    Jul 30, 2003
    Messages:
    8,525
    I would say either not on far enough or the bearing has "spun" on the axle shaft and is moving/walking around....not good at all
     
    jpflat2a, Jul 3, 2007
    #2
New Posts