1. Registration trouble? Please use the "Contact Us" link at the bottom right corner of the page and your issue will be resolved.
    Dismiss Notice

Poppett ball for a D20

Discussion in 'Intermediate CJ-5/6/7/8' started by LarryD, Jul 1, 2007.

  1. Jul 1, 2007
    LarryD

    LarryD Member

    Gallup NM/ 4 Corners
    Joined:
    Jul 7, 2006
    Messages:
    637
    Does aneyone know what size the poppett ball is for the shift rails on a D20.
    I was reassembling mine when one whent flying. If I can figure out what size it is I will try Carquest and NAPA tomorow If no luck I will Call Herm but would like to try locally first. I am guessing 1/4 or 5/16 but I think It must be exact ot wont shift.
     
    LarryD, Jul 1, 2007
    #1
  2. Jul 2, 2007
    hudsonhawk

    hudsonhawk Well-Known Member

    North Texas...
    Joined:
    Feb 4, 2005
    Messages:
    1,939
    can you acurately measure the size of the hole you use to install it? It is just slightly smaller then that hole so that there is no interferance.
     
    hudsonhawk, Jul 2, 2007
    #2
  3. Jul 2, 2007
    LarryD

    LarryD Member

    Gallup NM/ 4 Corners
    Joined:
    Jul 7, 2006
    Messages:
    637
    Thanks, I finally found it. I used a large magnet on a stick like roofers use to sweep a lawn after replacing a roof. I got it in late last night. Now for the intrmediate shaft and I am nearly done
     
    LarryD, Jul 2, 2007
    #3
New Posts